Table of Contents
Advertisement
Selecting the input
Open the Input control and select HDMI, DP, DP ALT or Auto Source. When you are done,
press the joystick to exit current page and store.
Input
Input
Auto Source
Move
OK
The Function page
Open the Function page to adjust the functions, settings which you want using the arrows.
When you are done, toggle the joystick to the left or right to go back one level or use
to exit current page and store.
Picture
Mode - Standard
Picture
Brightness
Color
Contrast
Black Boost
Audio
Low Blue Light
Pertormance
OSD
ACM
HDR
System
Lightsense
Save Settings to...
Super Sharpness
Move
Enter
1.
Press the MENU key to open the OSD.
2.
Toggle the joystick to the up or down to select Picture from the OSD.Then toggle to the
right to navigate to the element you wish to adjust and press the joystick to enter it.
3.
Toggle to the left or right to adjust the sliding scales.
4.
The Picture menu can be used to adjust the Brightness, Contrast, Black Boost, Low
Blue Light, ACM,HDR,LightSense,Super Sharpness.
5.
Brightness: Adjust the brightness from 0 to 100.
-----------------------------------------------------------------------------------------------------------
Note: Adjusts the balance between light and dark shades.
6.
Contrast: Adjust the contrast from 0 to 100.
-----------------------------------------------------------------------------------------------------------
Note: Sets the degree of difference between light and dark areas.
7.
Black Boost: Adjust the black level from 0 to 10. Enhances shadows by increasing the
brightness without changing lighter shades.
8.
Low Blue Light: The display uses the low blue light panel. It complies with TÜV
Rheinland Low Blue Light Hardware Solution certification under factory reset/default
setting (Low Blue Light=Standard, Brightness: 80%, Contrast: 50%, CCT: Warm).
9.
ACM: Turn ACM on or off.
HDMI
On
Exit
100
50
5
Standard
Off
Off
Off
Off
X
X
Advertisement
Table of Contents
