Table of Contents
Advertisement
KEYLESSCHUCK
SeeFigure 5.
Yourdrill h asa keyless c huck. A sthename implies, you
canhand tighten orrelease drillbitsinthechuck jaws.
Grasp andhold thecollar ofthechuck withonehand.
Rotate thechuck body withyourotherhand. T hearrows
onthechuck indicate w hich direction t orotate thechuck
body inorder t o LOCK (tighten) or UNLOCK (release)
thedrillbit.
UNLOCK
(RELEASE)
DRILL B IT
_
CHUCK BODY
4!
INSTALLING
BITS
See Figure 7.
[]
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
[]
Open or close chuck jaws to a point where the
opening is slightly larger than the bit size you
intend to use. Also, raise the front of your drill
slightly to keep the bit from falling out of the chuck
jaws.
[]
Insert drill bit straight into chuck the full length of
the jaws as shown in figure 7.
UNLOCK
(RELEASE)
DRILL BIT
_
CHUCKBODY
41
CHUCK
JAWS
ib,
LOCK
(TIGHTEN)
CHUCK
JAWS
I
CHUCK COLLAR Fig. 5
_
ARNING:
Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or your hand could slip and come in contact
with rotating drill bit. This could cause an
accident resulting in serious personal injury.
BIT STORAGE
See Figure 6.
When not in use, bits provided with your drill can be
placed in the storage area located on the top of your
drill as shown in figure 6.
AREA
SCREWDRIVER
BITS
LOCK
(TIGHTEN)
CHUCKCOLLAR
RIGHT
Fig. 7
[]
Tighten the chuck jaws on drill bit.
[]
To tighten the chuck jaws on drill bit; grasp and
hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of
the arrow marked LOCK to tighten chuck jaws.
[]
Do not use a wrench to tighten or loosen the
chuck jaws.
_IL
ARNING:
Make sure to insert drill bit straight
into chuck jaws. Do not insert drill bit into chuck
jaws at an angle and then tighten, as shown in
figure 8. This could cause drill bit to be thrown
from drill, resulting in possible serious personal
injury or damage to the chuck.
Fig. 6
11
Fig. 8
Advertisement
Table of Contents
