Transmitter Status Led; Wearing The Bodypack - Shure GLXD4RPE Manual

① Antenna
Carries wireless signal.
② Status LED
LED color and state indicate transmitter status.
③ Power switch
Turns the transmitter on/off.
④ TA4M input port
Connects to a 4-Pin mini connector (TA4F) microphone or instrument cable.
⑤ USB-C charging port
Connect to USB battery charger.
⑥ Link button
◦ Press and hold within 5 seconds of power-on to manually link with receiver.
◦ Press momentarily to activate remote ID function.
⑦ Battery compartment
Holds 1 Shure rechargeable battery.
⑧ Microphone cartridge
GLXD2+ transmitter models are available with the following cartridge types: SM58, Beta 58, Beta 87A.

Transmitter Status LED

LED is green during normal operation.
LED color or flashing indicates a change in transmitter status as shown in the following table:
Color
Green
Red
Red/Green
Amber

Wearing the Bodypack

Clip the bodypack to a belt or slide a guitar strap through the bodypack clip as shown.
For best results, the belt should be pressed against the base of the clip.
State Description
Flashing (slow) Transmitter attempting relink with receiver
Flashing (fast) Unlinked transmitter searching for receiver
Flashes 3 times Indicates locked transmitter when power switch is pressed
On Battery life < 1 hour
Flashing Battery life < 30 minutes
Flashing Remote ID active
Flashing Battery error; remove and insert again, or replace battery
Shure Incorporated
8/39