Yamaha TT-R110E 2017 Owner's Manual page 51

Periodic maintenance and adjustment
4. If the engine oil is not between the
tip of the dipstick and the maxi-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Check the O-ring for damage, and
replace it if necessary.
6. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap,
the engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
1. Engine oil drain bolt
2. Gasket
4. Install a new gasket and the drain
bolt, and then tighten the drain
bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
5. Refill with the specified amount of
the recommended engine oil.
NOTICE
 In order to prevent clutch slip-
 Make sure that no foreign mate-
6. Check the O-ring for damage, and
2 1
1. Engine oil filler cap
2. O-ring
7. Install and tighten the engine oil
8. Start the engine, and then let it idle
7-9
Recommended engine oil:
See page 9-1.
Oil change quantity:
0.80 L (0.85 US qt, 0.70 Imp.qt)
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
rial enters the crankcase.
replace it if necessary.
1
2
filler cap.
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
ECA11621
7