Table of Contents
Advertisement
Figure 17. Loose five screws and then remove the heat sink
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
VRAM Absorber tape
Remove the fans
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 32
"Remove the heat sink" on page 38
Step 1.
Disconnect the fan cables from the system board and then release the antenna cables and EDP
cable from the cable guide.
Figure 18. Disconnect the fan cables and then release the cables
Step 2.
Remove six screws and then remove the fans.
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
39
Advertisement
Table of Contents
