Yamaha WR250R 2007 Owner's Manual page 21

on page 3-8.
NOTE:
The stopwatch will continue counting
when the vehicle is stopped. To stop
and/or resume counting, repeat steps 2
and 3.
Auto start
1. Push the "SELECT 1" button for at
least two seconds to set the auto
start.
NOTE:
When the stopwatch is set to auto start,
the stopwatch indicator "
distance-compensation tripmeter indi-
cator " " will start flashing, and the
digits in the display will start scrolling
from left to right.
INSTRUMENT AND CONTROL FUNCTIONS
2. When the vehicle starts moving,
the stopwatch will start counting.
3. Push the "SELECT 1" button and
"SELECT 2" button together to
stop the stopwatch.
" and the
4. To resume counting, push the
"SELECT 1" button and "SELECT
2" button together again.
NOTE:
The stopwatch will continue counting
when the vehicle is stopped. To stop
and/or resume counting, repeat steps 3
and 4.
Measurement mode (for calibrating
the distance-compensation tripme-
ter's reading)
The distance-compensation tripmeter
is a feature intended to provide a more
accurate tripmeter reading for enduro
riding. Calibrating this meter in accor-
dance with the distances specified on
the enduro course map will help famil-
iarize the rider with the course. In addi-
tion, calibrating the meter may also be
necessary when using tire, wheel,
chain sprocket sizes, etc. other than
specified. For further information con-
cerning the use of this meter, please
consult your nearby Yamaha dealer.
Calibrate the distance-compensation
tripmeter as follows.
To increase the reading, push the
"SELECT 1" button. To decrease the
reading, push the "SELECT 2" button.
Pushing and holding either button will
increase or decrease the reading con-
tinuously until the button is released.
NOTE:
Calibrating the reading of the dis-
tance-compensation tripmeter is possi-
ble
operation.
3-7
regardless of the stopwatch
2
3
4
5
6
7
8
9