Problems, Causes, Remedies - Saeco PRIMEA LINE Technical & Service Manual

5.6

Problems, causes, remedies

HELP MESSAGES DISPLAYED
Turn the appliance off and on to solve the problem
Call the Service Center
Insert drip tray
Close pre-ground coffee container cover
Insert ground coffee
Insert brew group
Insert coffee grounds drawer
Empty coffee grounds drawer
Close side door
Fill water tank
Empty drip tray below brew group
Insert milk tank
Prime circuit
The descaling cycle did not run correctly
Replace Aqua Prima filter
The cleaning cycle did not run correctly
Insert cappuccino maker
Rinse milk tank
Descale appliance
Standby
PRIMEA Chapter 05
REV. 02 - Mar. 07
HOW TO RESET MESSAGE
Switch off and after 30 sec. turn on the appliance to
restore normal operating conditions.
Problem requiring assistance of Service Center
Insert drip tray
Close the coffee granule container to enable delivery
of any beverage.
This message guides the user when this type of cof-
fee has been selected during personalised beverage
programming.
Insert brew groupin seat
Insert coffee grounds drawer
Remove coffee grounds drawer and empty.
N.B: The coffee grounds drawer must only be emptied
when the appliance is switched on. The drawer must
be removed for at least 5 seconds. If the drawer is
emptied when the appliance is switched off the mes-
sage is not reset.
Close service door.
Fill tank
Empty drip tray
Insert container in milk compartment
Start filling water circuit automatically. The appliance
will automatically try tofill the circuit5 times; if it fails,
contact the Service Center.
Repeat the operation as described in the relative
chapter in the instruction booklet.
This message is only displayed if the filter control is
enabled (see instruction booklet).
Replace the filterif:
1) 60 litres of water have been dispensed.
2) 90 days have elapsed since installation.
3) 20 days have elapsed since the coffee maker was
last used.
Repeat the operation as described in the relative
chapter in the instruction booklet.
Insert cappuccino maker in milk compartment
Cleancontainer after use
Run descaling cycle
Press " start"
20/20