Trouble-Shooting - Haier HWM105-826S6 User Manual

Trouble-shooting

If there is a fault or the machine does not operate correctly,remove the power plug before
checking the machine.Using diagnostic list below,please check if the machine requires
repair.If a repair is required,please contact our customer care team,do not try to fix it by
yourself.
Problem
The machine does not drain
or drain slowly.The display
shows E1.
The machine stops running
The display shows E2.
The machine does not spin
The display shows E3.
The display shows E4.
The display shows FA.
Will not
wash
The machine
does not work.
Will not
spin
There are abnormal
sounds inside the machine.
Possible causes
Is the drain hose blocked?
Is the drain hose set too
high?
The top lid is not closed.
Has the laundry been placed
unevenly in the machine?
Is the machine level?
Is the water tap closed or
has the water supply been
interrupted?
Is the water inlet valve
blocked?
Is the water pressure too
low?
The water level sensor has
failed.
Is there a power failure?
Is the power plug inserted
tightly?
Has the water level reached
preset position?
Is the power plug inserted
tightly?
Is the top lid closed?
Is the laundry distributed
unevenly in the machine?
Is the machine level?
Has the laundry been placed
unevenly in the machine?
Are there any foreign objects
inside the tub?
17
What to do
Remove the blockage.Press
Start/Pause button once more.
The height of the drain hose
should be less than 10cm.
Close the top lid.Press the
Start/Pause button once more.
Redistribute the load evenly.
Press the Start/Pause button
once more.
Level the machine.
Turn on the water tap. Press
Start/Pause button once more.
Clean the water inlet valve
then press the Start/Pause
button once more.
Use after the water pressure
is normal.
Please contact Customer
Care.
Wait for the power supply
to be restored.
Insert the power plug tightly.
Wait for the water to fill to
the preset level
Insert the power plug tightly.
Close the top lid. Press the
Start/Pause button once more.
Redistribute the laundry. Press
the Start/Pause button once more.
Level the machine.
Redistribute the load evenly.
Close the top lid. Press the
Start/Pause button once more.
Remove the foreign objects.