Memory Card - Stealth Cam STC-G26FX Instruction Manual

o
PIR VIDEO: In this mode the camera will take a video clip at a designated resolution for a
designated length with a designated time out when the camera senses activity in front of the
unit. This mode is available for both day and night activities.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this
setting is only active if TL Delay is set to 1 min or greater. This setting can be changed between the
numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN arrows
will allow the minutes setting to be changed from 00 to 59. Once this setting is on the appropriate
minutes, press the RIGHT arrow key to move to the seconds setting and it will start to blink. Use of the
UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes =
00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will
be activated. These distances can vary depending on environmental conditions. This setting will change
between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD
setting, or NEAR FIELD that will only trigger on movement closest to the camera.
"
VIDEO RES – 720 x 480 (default): This setting is used to determine the resolution of each video taken by
the camera. With this option blinking, use the UP or DOWN arrow key to move between the options of:
720 x 480 or 1280 x 720. The higher the resolution of a video the more space the file will take on the SD
memory card.
"
VIDEO LENGTH – 010 S (default): This setting is used to determine the length of time, in seconds, of the
video recording. This setting can be changed between the numbers of 10 to 180. With this option
blinking, use the UP or DOWN arrow key to move between the value range in increments of 5. The
maximum night video is 30 seconds to conserve the batteries.
"
VIDEO AUDIO – ON (default): This setting is used to determine if the camera should record audio
(sound) with its video recording. With this option blinking, pressing the UP or DOWN arrow buttons will
cause the camera to cycle between the two options of ON or OFF.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
12