Maintenance; Specifications - Magnat Audio MONITOR SUPREME SUB 302A Instruction Manual

AV input (2)
Connect your receiver's low-level subwoofer output (sub-pre-out) to the subwoofer's AV input (see Fig.
3). You will require a mono-cinch cable for this (not supplied).
High-level inputs (1)
For connection to the high-level (speaker) outputs of the receiver/amplifier, refer to Fig. 2.
Level control (3)
This control is used to set the bass volume according to your preferences. Proceed as follows::
1. Set the bass control of your amplifier into its centre (linear) position.
2. Important: Set the level control to its left stop (lowest volume).
3. Now, play back some music and set the volume control of the amplifier to the desired level.
4. Set the subwoofer level control to the desired bass level.
Cross-over frequency control (4)
Used to set the upper limit of the subwoofer operating range. The cross-over frequency should be set
to 100 to 150 Hz when the system is used in combination with shelf loudspeakers or 50 to 100 Hz when
used with stand loudspeakers.
Fuse (9)
Only use a fuse with the parameters indicated inside the triangle next to the fuse holder, on the rear of
the amplifier.

MAINTENANCE

The surface is best cleaned with a mild household cleaner. On no account use furniture polish or similar
products.

SPECIFICATIONS

Configuration:
Fitted with:
Output power RMS/Max.:
Frequency range:
Cross-over frequency:
Power input (Standby):
Dimensions (WxHxD):
Accessories:
Subject to technical change.
Monitor Supreme Sub 202A
bass reflex, frontfire
20 cm long-stroke driver
80 / 160 watts
20 – 200 Hz
50 – 150 Hz
<0.5 watts
265 x 365 x 345 mm
mains cable
9
Monitor Supreme Sub 302A
bass reflex, frontfire
30 cm long-stroke driver
100 / 220 watts
16 – 200 Hz
50 – 150 Hz
<0.5 watts
355 x 440 x 395 mm
mains cable