Table of Contents
Advertisement
Water supply pressure
1)
2)
Water supply
Maximum Load
Spin Speed
1)
The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot connect
the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your domestic cold water
storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the appliance inlet hose and the
bottom of the water storage tank.
2)
Connect the water inlet hose to a water tap with a 3/4'' thread.
5. INSTALLATION
WARNING!
Refer to Safety chapters.
5.1 Unpacking
1. Open the door and remove the
polystyrene piece from the door seal and
all the items from the drum.
Accessories delivered with the
appliance may vary depending on the
model.
2. Put the packaging element on the floor
behind the appliance and carefully put it
down onto its rear side. Remove the
polystyrene protection from the bottom.
8
ENGLISH
Minimum
Maximum
Cotton
Maximum spin speed
Do not lay washing machine on its front.
3. Put the appliance back into an upright
It is possible to see water flowing from
the drain hose. This is because the
washing machine has been tested at the
factory.
4. Remove the three bolts and pull out the
0.5 bar (0.05 MPa)
10 bar (1.0 MPa)
Cold water
9 kg
1351 rpm
1
CAUTION!
position. Remove the power supply cable
and the drain hose from the hose holders.
WARNING!
plastic spacers.
2
Advertisement
Table of Contents
