Table of Contents
Advertisement
USB Mass Storage Driver Support
The item allows you to enable or disable USB Mass Storage Driver Support.
Options: Enabled (Default) / Disabled
Port 60/64 Emulation
The item allows you to enable or disable I/O port 60h/64h emulation support. This should be
enabled for the complete USB keyboard legacy support for non-USB aware OSes.
Options: Enabled (Default) / Disabled
USB transfer time-out
The time-out value for Control, Bulk, and Interrupt transfers.
Options: 20 sec (Default) / 1 sec / 5 sec / 10 sec
Device reset time-out
The item sets USB mass storage device Start Unit command time-out.
Options: 20 sec (Default) / 10 sec / 30 sec / 40 sec
Device power-up delay
Maximum time the device will take before it properly reports itself to the Host Controller.
"Auto" uses default value: for a Root port it is 100ms, for a Hub port the delay is taken from Hub
descriptor.
Options: Auto (Default) / Manual
Note
» The following items appear only when you set the Device power-up delay function to [Manual].
Device power-up delay in seconds
Delay range is 1 ~ 40 seconds, in one second increments.
Options: 5 (Default)
USB FLASH DRIVE PMAP
Mass storage device emulation type. 'AUTO' enumerates devices according to their media format.
Optical drives are emulated as 'CDROM' , drives with no media will be emulated according to a
drive type.
Options: Auto (Default) / Floppy / Forced FDD / Hard Disk / CD-ROM
14 | 2. Advanced Menu
Advertisement
Table of Contents
