GPX v1303-01 User Manual page 7

CD, Radio & 3.5mm Aux In
Loading and Playing a CD
Note: This unit is not compatible with MP3 CDs.
1. Press the Source button to switch to CD mode.
2. Open the Disc door.
3. Load a CD or CD-R/RW disc into the unit,
label side facing up.
4. Close the Disc door.
5. Press the Play/Pause button to begin playing the
loaded CD. Press the Skip/Search buttons to cycle
through different tracks.
Programming a CD
1. Press the Stop button to stop the CD.
2. Press the Prog/Mem button on the remote.
3. Press the Skip/Search buttons to select a track from the
loaded CD to play first.
4. Press the Prog/Mem button again.
5. Repeat steps 3 and 4 to program tracks from the loaded
CD to play in the order they are selected.
6. Press the Play/Pause button to begin playing the
programmed CD.
7. Press the Stop button twice to cancel
the program.
Customer Support: 1-888-999-4215
AM/FM Radio
An AM/FM antenna is built into the music system. Adjust
the position of the unit to adjust radio reception.
1. Press the power button to turn the player on.
2. Press the Source button to switch to FM or AM radio
mode.
3. Press the Tuning/REV/FWD buttons to adjust to a radio
station.
Programming Radio Stations
1. With the unit on and in AM or FM mode, press the Tune
+/− buttons to adjust to a radio station.
2. Press the Prog/Mem button on the remote.
3. Press the Mem +/− buttons to select a preset number.
Up to 20 stations may be preset.
4. Press the Prog/Mem button on the remote to save the
stations.
5. Use the Mem +/− buttons to cycle through your
memory presets.
3.5mm Aux In
Requires a 3.5mm audio cable (not included)
1. Connect a 3.5mm audio cable to the Aux In on the unit
and the audio output/headphone jack on a media
player.
2. Press the Source button to switch to Aux mode.
3. Use the controls on the connected device to select and
play audio.
7