Table of Contents
Advertisement
15. Arrange and install the domestic cold in isolation valve (G1) and a stub of 15mm pipe (G4) using 15mm
compression nut (G3) and olive (G2).
16. Fix the ½" x ½" x 3/4" isolating tee valve (G7) to the cold water feed pipe (G4) using 15mm compression
nut (G5) and olive (G6). Ensure to arrange the blue lever on the Tee so it is easily accessible for your
customer.
⚠
I I I I f your customer has a water softener installed you must attach the isolating Tee valve
f your customer has a water softener installed you must attach the isolating Tee valve (G7)
f your customer has a water softener installed you must attach the isolating Tee valve
f your customer has a water softener installed you must attach the isolating Tee valve
unsoftened cold water source, the cold water in flexible hose (F1)
unsoftened cold water source, the cold water in flexible hose
unsoftened cold water source, the cold water in flexible hose
unsoftened cold water source, the cold water in flexible hose
or unsoftened water source.
or unsoftened water source.
or unsoftened water source.
or unsoftened water source.
17. Connect the domestic cold in flexible hose (F1) to the ½" x ½" x 3/4" isolating tee valve (G7) using 15mm
compression nut (G5), olive (G6) and a section of 15mm pipe (F5).
18. Screw the ¾" BSP x ¼" pushfit (C9) onto the three-way valve (G7) ¾" male output.
Install the Filter:
Install the Filter:
Install the Filter:
Install the Filter:
1. Find a suitable place to mount the filter cartridge (C7) under the sink, it must be mounted vertically
accessible (to be changed periodically), away from any heat source or electrical connections and close enough
not to exceed the available length of the ¼" plastic pipe (B4,C4,C8) supplied to reach the between the tap, filter
and boiler (place the boiler temporarily to help judge the required lengths of ¼" plastic pipe).
2. Using the self-tapping screw (C6) securely fix the filter bracket (C5) to the cabinet wall.
3.
Write the installation date onto the filter label in permanent pen.
4. Clip the filter cartridge (C7) into the bracket (C5) as shown.
You must observe the direction of flow as indicated on the filter cartridge (C7).
5. Measure and then cut required length of ¼" pipe (C4) to connect pushfit (C3) to the filter cartridge (C7) outlet,
allow a small amount of extra length to make it easier to change the filter.
6. Firmly push connect the ¼" pipe (C4) between pushfit (C3) and filter cartridge outlet (C7).
7. Measure and then cut required length of ¼" pipe (C8) to connect pushfit (C9) to the filter cartridge (C7) inlet,
allow a small amount of extra length to make it easier to change the filter.
8. Firmly push connect the ¼" pipe (C8) between pushfit (C9) and filter cartridge inlet (C7).
9. Firmly push connect the remaining ¼" pipe (B4) into pushfit (B3).
(F1) can however connect
can however connect to either a softened
(F1)
(F1)
can however connect
can however connect
it must be mounted vertically, easily
it must be mounted vertically
it must be mounted vertically
(G7) to an
to an
(G7)
(G7)
to an
to an
to either a softened
to either a softened
to either a softened
Advertisement
Table of Contents
