Troubleshooting - Honeywell HeatGenius HCE840 Series Manual

SAFETY FEATURES
The Honeywell HeatGenius
added protection:
• A four way tip-over switch that disables the heater if it is accidently tipped in any direction. If tipped over,
the unit should be set upright and follow the OPERATION instructions.
• A high temperature safety control prevents overheating. If activated, unplug the device and wait at least
10 minutes for unit to cool. Then plug the heater back in and follow the OPERATION instructions.
• The heater is also equipped with a thermal cut-off fuse that will permanently shut down the heater should
it operate at a highter than normal temperature. If activated, the unit will need to be replaced.
• This heater was created using high quality, heat-resistant plastics and has a Cool Touch handle.
FAHRENHEIT TO CELSIUS
• Press and hold both Thermostat Control Buttons (
and Celsius and back.
CLEANING AND STORAGE
It is recommended that the Honeywell HeatGenius
before off-season storage.
• Turn Off ( ) and unplug heater. Allow unit to cool.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES,
POLISHES OR ANY CHEMICAL SOLUTION.
• Before storing, clean the Ceramic Heater using the above-mentioned steps. Wrap the cord around the
unit. Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.

TROUBLESHOOTING

Problem
If your Honeywell HeatGenius
Ceramic Heater shuts off
unexpectedly or fails to
operate, one of your heater
safety features may have
been activated to prevent
overheating.
PRODUCT SPECIFICATIONS
Model(s) Unit dimensions
HCE840B / 10.2" L x 5.6" W x 17.3" H
HCE840BC
Ceramic Heater is equipped with several devices and features for
TM
TM
Solution
• Be sure it is plugged in and that the electrical outlet is working.
TM
• Check for any obstructions. If you find an obstruction, turn the heater
OFF ( ) and unplug it.
• Allow the heater to cool completely, then remove the obstruction,
ensuring that the heater has not been damaged in any way. Wait
at least 10 minutes, then re-plug the heater in and follow the
OPERATION instructions.
) for three seconds to change between Fahrenheit
Ceramic Heater be cleaned at least once a month and
Amps Unit
Voltage
12.5 120V, 60Hz
Max Max BTUs
Watts
1575 5118
5