Table of Contents
Advertisement
Figure 14
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to
Bag-on-Demand Lever (page
Installing the Grass Bag
1.
Raise and hold up the rear deflector (A of
2.
Install the grass bag, ensuring that the pins on the bag rest in the slots on the handle bracket (B of
Figure
15).
3.
Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
g334136
14).
Figure
Removing the Grass Bag (page
Shutting Off the Engine
Service Interval: Before each use or daily—Ensure
that the engine shuts off within
3 seconds after releasing the
blade-control bar.
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position, move
the lever to the recycling position; refer to
the Bag-on-Demand Lever (page
15).
Figure 15
13).
13
Operating
14).
Operating the
g233434
Advertisement
Table of Contents
