Page 1
Dishwasher User’s Manual BM 5015 X BM 5015 B Document Number : 1728767139_AB_BEKO_BM 5015 X_BM 5015 B_EN/ 04-02-19.(14:15)
Page 2
Please read this user manual first! Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
Page 3
Dishwasher User’s Manual BM 5015 X BM 5015 B Document Number : 1728767139_AB_BEKO_BM 5015 X_BM 5015 B_EN/ 04-02-19.(14:15)
Page 4
Please read this user manual first! Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
CONTENTS 1 INSTRUCTIONS FOR SAFETY adjustable service rack ..... 23 Lower basket bottle wire ....24 AND ENVIRONMENT Upper basket height adjustable rack 24 General safety ........4 Upper basket multipurpose service Intended use ..........4 rack ............24 Children’s safety ........5 Adjusting the height of the upper Disposing of packaging material ..5 basket ..........
instructions for safety and environment This section contains safety wet hands! Never unplug by instructions that will help to get pulling on the cable, always protected from risk of personal pull out by grabbing the plug. injury or property damage. Failure The product must be •...
instructions for safety and environment to be used in household and the product. similar applications such as: Do not forget to close the • - Staff kitchen areas in shops, door of the product when offices and other working leaving the room where it is environments;...
instructions for safety and environment Compliance with RoHS 1. Unplug the product before transporting it. Directive 2. Remove water drainage and The product you have purchased water supply connections. complies with EU RoHS Directive 3. Drain the remaining water in (2011/65/EU).
Dishwasher Technical specifications Compliance to standards and test data / EC declaration of conformity This product complies with the following EU directives; Development, production and sales stages of this product comply with the safety rules included in all pertaining European Community regulations. 2014/35/EU, 2014/30/EU, 93/68/EC, IEC 60436/DIN 44990, EN 50242 Power input 220-240 V, 50 Hz (see rating label)
Installation Appropriate installation Refer to the nearest Authorised Service Agent for installation of your product. To location make the product ready for use, make sure Place the product on a solid and flat • that the electricity, tap water supply and floor that has sufficient load carrying water drainage systems are appropriate capacity! The product must be...
Installation Connection to the drain Permitted water temperature: up to 25°C Water discharge hose can directly be connected to the drain hole or sink’s drainage. The length of this connection Do not use old or used water inlet • must be min. 50 cm and max. 100 cm from hose on the new product.
Installation Dishwashers door must be If the product has a failure, it aligned properly otherwise hot should not be operated unless steam can escape! Danger of it is repaired by the Authorised serious burns, other injury or Service Agent! There is the risk may damage furniture.
Preparation Tips for energy saving Adjusting the water softening system Following information will help you use the product in an ecological and energy- Cleaning, rinsing and drying performance of efficient manner. your dishwasher will increase when water Wipe away any coarse food remnants on softening system is adjusted properly.
Page 15
Preparation After determining hardness level of the supply water: 1. Turn on the machine, press and hold Time Delay and Programme keys simultaneously for 3 seconds to enter the settings menu. 2. Press the programme key until the Salt indicator starts to flash. Current regeneration stage is displayed on the programme indicator.
Preparation illuminate continuously although it is not Firstly, take the lower basket out to add necessary to use salt. If you use salt under softening salt. this condition, salt will not be consumed 2. Turn the salt reservoir lid counter- and the Salt indicator will not illuminate.
Preparation You need to add salt right before Do not put solvents into the starting the machine. Thus, the detergent dispenser. There is overflowing salty water will be the risk of explosion! flushed immediately, preventing Put the detergent into the detergent the risk of corrosion in machine.
Preparation together with the detergent if the water 3. Push the lid of the detergent dispenser hardness level is above the mentioned level. to close it. A "click" will be heard when the lid is closed. The best washing performance in dishwashers is obtained by using detergent, rinse aid and water softening salt individually.
Preparation Rinse aid 4. If there are stains on tableware items after washing, level must be increased The rinse aid used in and if there is a blue trace after wiping dishwashers is a special them by hand, it must be decreased. combination that aims to This is set to position 3 as factory increase drying efficiency and...
Preparation Placing the dishes into the dishwasher You can use your dishwasher in the optimum way with respect to energy consumption and washing and drying performance only if you place the dishes in an orderly way. Wipe away any coarse food remnants •...
Page 21
Preparation Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware Dishwasher / User’s Manual 19 / 44 EN...
Preparation Cutlery basket Cutlery basket (depends on model) (depends on model) Cutlery basket is designed to wash your Cutlery basket is designed to wash your dishes such as knife, fork, spoon, etc. in an dishes such as knife, fork, spoon, etc. in an efficient manner.
Preparation Collapsible lower basket Bringing the tines to the tines horizontal position by holding them from the tips may cause (depends on model) them to bend. Therefore, it There are foldable tines (A) located at the will be appropriate to bring the tines in the middle to horizontal lower basket of the machine are designed or vertical position by holding...
Preparation SoftTouch Accessory (depends on model) The SoftTouch Accessory found in the lower basket of your machine enables a safe washing for your fragile glasses. Bringing the tines to the horizontal position by holding them from the tips may cause them to bend.
Preparation Lower basket multipurpose Make sure that the impeller / height adjustable service does not touch the dishes you rack placed on the racks. (depends on model) To close the racks: This accessory located at the lower basket Fold the rack (A). of your machine allows you to easily wash 2.
Preparation Lower basket bottle wire (depends on model) The bottle wire is designed for easier washing of long pieces with wide mouths. You may take out the bottle wire from the basket when not in use by pulling it out from both sides (H).
Preparation Adjusting the height of the To lower the basket, while it is in the uppermost position; upper basket Hold the upper basket wires with both (depends on model) hands, slightly lift up the basket and The upper basket height adjustment simultaneously push and release the mechanism has been designed for you to latches shown in the figure (B).
Preparation Collapsible upper basket Pull the basket out completely. Place the basket back into the tracks at the wires desired height. (depends on model) Push the latches back into the correct You can use collapsible wires when you position. need a larger space for your dishes in the upper basket of your machine.
Preparation Ceiling cutlery basket (depends on model) Ceiling cutlery basket is designed to wash your cutlery items such as forks, spoons and etc. by placing them between the bars on the basket. When the central tray is in the lower position, you can load long/high items such as coffee cups, ladles, etc.
Operating the product Keys Programme selection On/Off key Press On/Off key to turn on your It is used to turn on or off the machine. machine. Machine will turn on with economy 2. Refer to the table of "Programme data programme in On mode and the number of and average consumption values"...
Page 32
Operating the product /44 EN Dishwasher / User’s Manual...
Operating the product Auxiliary functions selection indicator and on the display. 4. Start the programme by pressing Start / Washing programmes of your dishwasher Pause / Cancel key. are designed to obtain the best cleaning effect, considering the type of the soiling, soiling degree and properties of the dishes With the Half Load function you to be washed.
Operating the product Scheduling the washing Floor illumination Warning to show that machine is time in washing phase Time Delay (depends on the model) If an economical electricity tariff is applied Your machine reflects a light to the floor in your region, you can use the Time during the washing process.
Operating the product Starting the programme To exit time delay mode without activating the Time To start your machine after selecting the Delay, press the time delay key programme and auxiliary functions, press until the 3-6-9 hours duration Start/Pause/Cancel key. indicators disappear.
Operating the product Cancelling the programme Adjusting the amount of Press Start/Pause/Cancel key for 3 rinse aid seconds to cancel the programme. After turning on the machine, 2. Release the key when the programme press and hold Time Delay and P keys indicator starts flashing.
Operating the product Leave your dishes in the machine for about 15 minutes to allow them cool down after they are washed. Your dishes will dry in a shorter time if you leave the door of your machine ajar during this period. This process will increase the drying effectiveness of your machine.
Maintenance and cleaning Cleaning the filters Service life of the product extends and frequently faced problems decrease if it is Clean the filters at least once a week in cleaned at regular intervals. order for the machine operates efficiently. Unplug the product and turn off Check if food residues are left on the filters.
Maintenance and cleaning Cleaning the hose filter Damages on the machine that may be caused by impurities coming from the urban supply water or your own water installation (such as sand, dirt, rust, etc.) can be prevented by means of the filter attached to the water inlet hose.
Maintenance and cleaning Cleaning the impellers Upper impeller Clean the impellers at least once a week in Check if the holes on the upper impeller (1) order for the machine operates efficiently. are clogged. If they are clogged, remove and clean the impeller. Turn its nut to left to Lower impeller remove the upper impeller.
Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. •...
Page 42
Troubleshooting • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine. • Machine is unloaded right after the programme is over. >>> Do not unload your machine right after washing process is completed.
Page 43
Troubleshooting the filling process. Run the prewash programme to remove the salt that spilled inside the machine. Since the salt granules that will remain under the lid will dissolve during prewash, causing the lid loosen, check the lid once again at the end of the programme. There is a different odour in the machine A new machine has a peculiar odour.
Page 44
Troubleshooting Detergent remains in detergent dispenser. • Detergent dispenser was damp when adding detergent. >>> Make sure that the detergent dispenser is dried well prior to filling it with detergent. • Detergent is added long before the washing process. >>> Pay attention to add detergent shortly before start-up of the washing.
Page 45
Troubleshooting A smear remains on glasses that resembles milk stain which can not be removed when wiped by hand. A bluish / rainbow appearance occurs when the glass is pointed to light. • Excessive rinse aid is used. >>>Lower rinse aid setting. Clean the spilled rinse aid when adding rinse aid.