Table of Contents
Advertisement
Steps
1. Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
2. Replace the seven (M2x2) screws that secure the touchpad and touchpad bracket to the palm-rest and keyboard assembly.
3. Connect the touchpad cable to the system board and close the securing latch.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
I/O board
Removing the I/O board - shipped with flexible printed circuit
(FPC)
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state drive
6. Remove the
solid-state drive
7. Remove the
wireless
card.
8. Remove the
memory
module.
9. Remove the
right
fan.
10. Remove the
left
fan.
11. Remove the
system
board.
After working inside your
Before working inside your
1.
2.
computer.
computer.
Removing and installing components
27
Advertisement
Table of Contents
