Installing Software - 3Com NETBuilder II DPE 80 Manual

Installing Software

3 Verify that configurable parameters of your console match the configuration
settings of the CONSOLE port specified in Table 1-1.
Table 1-1 CONSOLE Port Configuration Settings
Characteristic
Baud rate
Databits
Parity
Stop bits
DTR
Duplex
Echo
Flow control
4 Turn on the console.
If you have bought the software from 3Com preinstalled on a flash memory
card, insert the card into drive A, the top flash memory drive. The default boot
and configuration file paths are to a directory on drive A.
Refer to the release notes for approved vendors of blank flash memory cards for
backup. The software guide describes how to format a blank card.
For information about configuring the NETBuilder II software, refer to the
software guides that shipped with your software package.
Setting
9600
8
None
1
Ignored
Full
Off
X-on/X-off
Installing Software 1-7