Ryobi RPD1010 Original Instructions Manual page 4

cold and dampness, diet, smoking, and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
Keep your body warm in cold weather. When operating
the product, wear gloves to keep the hands and wrists
contributing to Raynaud's Syndrome.
After each period of operation, exercise to increase
blood circulation.
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 91.
1. Keyless chuck
2. Drill/impact shift knob
3. High/low speed selector
4. Variable Speed Selector
5. Forward/ Reverse button
6. Lock-on button
7. Power light
8. Auxiliary handle, insulated gripping surface
9. Depth Gauge
10. Handle, insulated gripping surface
MAINTENANCE
WARNING
The product should never be connected to a power
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
2
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Electrical tools used on fiberglass material, wallboard,
accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc. We
do not recommend using the product for extended work
on these types of materials.
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
All of the bearings in the product are lubricated with
a sufficient amount of high-grade lubricant for the life
span of the product under normal operating conditions.
Therefore, no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
V Volts
Hz Hertz
Alternating current
W Watts
n No-load speed
o
Revolutions or reciprocations per minute
Class II tool, double insulation
English