NEC LCD3090WQXI-BK-R User Manual page 30

6. Using "LEFT" or "RIGHT" of Display B, select COPY in the MODE selection (Figure C.7). Select ON of OFF in the SELF
selection. If ON selected, SELF Calibration execute with COPY Calibration.
7. Select the target GAMMA: NO CORRECTION, 2.2, OPTION, PROGRAMMABLE and CUSTOM. Please select the same
target GAMMA as Display A.
NOTE: If CUSTOM is selected, the Gamma Value can be manually changed in intervals of 0.1 at 0.5-4.0.
8. The procedure will ask for the USB sensor to be placed on the center of the display panel (Figure C.8). Tilt the display
panel approximately 5˚ backward and place the USB sensor in the center of the display panel (Figure C.1).
NOTE: Place the USB sensor flat against the display to avoid external light contamination. Do not press the calibrator
against the display panel. Press "SELECT".
9. Press SELECT on Display B to start reading the white point information of Display A.
10. After copying Display A information, the target luminance will be stored and displayed in the OSD of Display B.
The target value is not adjustable (Figure C.9).
Figure C.7
11. Remove USB sensor from source Display A and place in the center of Display B (Figure C.2).
12. Press SELECT to start the copy calibration. Copy calibration may take several minutes depending on user settings.
13. Once the calibration is successfully completed, the white points of Display A and Display B should match. After the
CALIBRATION SUCCEEDED message appears (Figure C.10), press SELECT to continue into the Fine Tuning mode.
14. At the FINE TUNING MODE message (Figure C.11), press EXIT if the calibration is satisfactory. If the calibration is
unsatisfactory, there are two options:
(A) Manually fine tune the white point using the "LEFT" and "RIGHT" keys.
(B) Restart the automatic copy calibration, press SELECT and return to Step 3.
15. To end the calibration mode, press "EXIT".
Figure C.8
Figure C.10
English-28
Figure C.9
Figure C.11