Mitsubishi Electric SUZ-KA18NA2 Service Manual page 18

10-3-2. Remote controller check <PAR-3xMAA ("x" represents 0 or later)>
If operations cannot be completed with the remote controller, diagnose the remote controller with this function.
Select "Service" from the Main menu, and press the
1
Select "Remote controller check" with the F1 or F2 button, and press the
button.
Select "Remote controller check" from the Service menu, and press the
2
ton to start the remote controller check and see the check results.
To cancel the remote controller check and exit the Remote controller check
menu screen, press the
The remote controller will not reboot itself.
3
OK: No problems are found with the remote controller. Check other parts
for problems.
E3, 6832: There is noise on the transmission line, or the indoor unit or another
remote controller is faulty. Check the transmission line and the other
remote controllers.
NG (ALL0, ALL1): Send-receive circuit fault. Remote controller needs replacing.
ERC: The number of data errors is the discrepancy between the number of
bits in the data transmitted from the remote controller and that of the
data that was actually transmitted over the transmission line. If data er-
rors are found, check the transmission line for external noise interfer-
ence.
If the button is pressed after the remote controller check results are displayed,
remote controller check will end, and the remote controller will automatically re-
boot itself.
Check the remote controller display and see if anything is displayed (in-
cluding lines). Nothing will appear on the remote controller display if the
correct voltage (8.5–2 V DC) is not supplied to the remote controller. If
this is the case, check the remote controller wiring and indoor units.
OCH688D
or the button.
button.
but-
18
S e v r c i e m e n u
Maintenance password
Remote controller check
M a n i m e n : u
C u s r r o
F1 F2 F3 F4
Remote controller check
Start checking?
B e i g : n
F1 F2 F3 F4
Remote controller check results screen
Remote controller check
Start checking?
B e i g : n
F1 F2 F3 F4