Table of Contents
Advertisement
This submenu allows you to change voltage and clock of various devices.
Note
»
We suggest you use the default setting. Changing the voltage and clock improperly may damage the
device.
»
The options and default settings might be different by RAM, CPU and motherboard models.
»
Beware of that setting inappropriate values in items of this menu may cause system to malfunction.
- Values in Red: Danger
- Values in Yellow: Warning
- Values in White: Normal
Start Page
You can set the entrance page when you enter UEFI BIOS Setup.
Options: Page – Main (Default) / Page – Advanced / Page – Chipset / Page – Boot / Page – Security
/ Page –O.N.E / Page – Save & Exit
Clock Frequency
Specifies new frequency to be applied. Frequency is rounded to nearest valid value. Allowed
range is limited by the Max/Min supported frequencies. Changes are not applied until settings are
saved and platform resets.
Spread %
Specifies the amount of spread spectrum clocking to be applied to the base clock frequency in
0.01% increments. Allowed range is limited by Maximum Spread % and supported Spread mode
Adjustments. If Changes Allowed, a value between 0 and Max Spread % can be specified. Value is
adjusted to settings supported by HW. If only Halt Allowed, only 0% and default spread % can be
specified. Changes are not applied until settings are saved and platform resets.
28 | 6. O.N.E Menu
6� O�N�E Menu
Advertisement
Table of Contents
