Operation - Zenoah EBZ8560 Operator's Manual

7. Loosen the knob (H) to adjust the position of the
handle.
8. Tighten the knob again.
To adjust the harness
A correctly adjusted harness and product makes
operation easier.
Introduction
WARNING:
the safety chapter before you use the
product.
Fuel
To use fuel
CAUTION:
stroke engine. Use a mixture of gasoline
and two-stroke engine oil. Make sure
to use the correct quantity of oil in the
mixture. Incorrect ratio of gasoline and
oil can cause damage to the engine.
Gasoline
CAUTION:
an octane number less than 90 RON
(87 AKI). This can cause damage to the
product.
CAUTION:
more than 10% ethanol concentration
(E10). This can cause damage to the
product.
CAUTION:
gasoline. This can cause damage to the
product.
• Always use new unleaded gasoline with a
minimum octane number of 90 RON (87 AKI)
10
H

Operation

Read and understand
This product has a two-
Do not use gasoline with
Do not use gasoline with
Do not use leaded
1. Put on the harness of the product.
2. Tighten the side straps until the product is tight
against your body.
and with less than 10% ethanol concentration
(E10).
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
• Always use a good quality unleaded gasoline/oil
mixture.
Two-stroke oil
• For best results and performance use Zenoah
two-stroke oil, which is specially formulated for
our two-stroke engines.
• If Zenoah two-stroke oil is not available, you may
use another two-stroke oil of good quality that
is intended for air cooled engines.Contact your
dealer when you select an oil.
• Do not use two-stroke oil intended for water-
cooled outboard engines, also referred to as
outboard oil.
• Do not use oil intended for four-stroke engines.
Gasoline, litre
5
10
15
20
To make the fuel mixture
Note:
Always use a clean fuel container when you
mix the fuel.
Two-stroke oil, litre
2% (50:1)
0.10
0.20
0.30
0.40
2142 - 005 - 06.07.2023