30302005GB.fm Page 11 Tuesday, March 14, 2006 3:09 PM
INSTALLATION
• Install the freezer away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near
heat sources (heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must
be respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
• Install the appliance in a dry, well-ventilated place.
• Clean the inside (see "How to defrost and clean the freezer").
• Fit the accessories supplied (Fig. 1 and 2).
Electrical connection
• Electrical connections must be made in accordance
with local regulations.
• Voltage and power consumption are indicated on the rating
plate inside the appliance.
Regulations require that the
•
The Manufacturer declines all liabilities for injury to
persons or animals or damage to property resulting
from failure to observe these regulations.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
Electrical disconnection must be possible either by unplugging
the appliance or by means of a double-pole switch located upline
from the socket.
appliance is earthed.
Fig. 1
Fig. 2
11