Sony BRAVIA KDL-22L5000 Additional Information For Using page 3

Step 5: Preparing the TV for wall mount installation
Follow the steps below to prepare for installing the TV.
1 Disconnect all the cables from the TV.
2 Align the holes on the left Mounting Hook with the corresponding holes on the
rear of the TV.
Secure them to the TV using two screws (supplied with SU-WL00).
When using an electric screwdriver to tighten the screws, the torque must be approximately
.5 N·m (5 kgf·cm). Do not lift the Mounting Hook before the screws (two screws each for
left/right) are secured.
Hook locations diagram
KDL-6L5000: Install the TV onto the location "a" of the Base Plate.
KDL-L5000: Install the TV onto the location "b" of the Base Plate.
Additional Information for Using Sony Wall-Mount Bracket (SU-WL100)
Screw
(+PSW 4 × 12)
Mounting Hook
a
b
−  −