Table of Contents
Advertisement
Menu
Item
P-NR
3D-COMB
Panel
Advanced Settings Sets the detailed picture settings (p. 31)
Reset to Defaults Press the OK button to reset the present Picture Menu settings to the default.
Mode
Bass
Treble
Equalizer
Balance
Headphone Volume Adjusts the volume of the headphones
Surround
Volume Correction Adjusts the volume of individual channel or input mode
Speaker Distance
to Wall
MPX
Adjustments / Configurations (alternatives)
Picture Noise Reduction
Automatically reduces unwanted picture noise and flicker noise in the
contoured parts of a picture (Off / Min / Mid / Max)
●
Not valid on PC signal
Makes still or slow moving pictures look more vivid (Off / On)
●
Occasionally, while viewing still or slow moving pictures, colour
patterning may be seen. Set to "On" to display sharper and more
accurate colours.
●
For PAL or NTSC signal reception only
●
Not valid, on Component, PC, HDMI and Media Player
Turns the screen off when you select "Off" (Off / On)
●
The sound is active even if the screen turns off.
●
Press any buttons to turn the screen on.
●
This function is effective in reducing power consumption when listening
to a sound without watching the TV screen.
Selects basic sound mode (Music / Speech / User)
●
The selected mode affects all input signals.
Music : Improves sound quality for watching music video, etc.
Speech : Improves sound quality for watching news, drama, etc.
●
In Music and Speech mode, you can adjust "Bass" and "Treble"
settings, and those settings will be stored for each mode.
User
: Adjusts the sounds manually by using the equalizer to suit your
favourite sound quality.
●
For the User mode, "Equalizer" will appear on the Sound Menu instead
of "Bass" and "Treble". Select the "Equalizer" and adjust the frequency.
"Equalizer" (below)
Increases or decreases level to enhance or minimise lower, deeper sound output
Increases or decreases level to enhance or minimise sharper, higher sound output
Adjusts the frequency level to suit your favourite sound quality
●
This function is available when "Mode" is set to "User".
●
Select the frequency and change the frequency level by using the cursor button.
●
If you want to enhance the bass sound, raise the level of the lower
frequency. If you want to enhance the treble sound, raise the level of the
higher frequency.
●
To reset the levels of each frequency to the default settings, select the
"Reset to Defaults" by using cursor button, and then press the OK button.
Adjusts the volume level of right and left speakers
Surround sound settings (Off / V-Audio / V-Audio Surround / V-Audio
ProSurround)
V-Audio
: Provides a dynamic enhancer to simulate improved
spatial effects
V-Audio Surround
: Provides a dynamic enhancer of width and depth to
simulate improved spatial effects
V-Audio ProSurround : Provides a three-dimensional sound space with
digital reverb effects
●
Switching is also possible by the Surround button on the remote control (p. 10).
Adjusts the low frequency sound (Over 30cm / Up to 30cm)
●
If the back space between the TV and wall is over 30 cm, "Over 30cm"
is recommended.
●
If the back space between the TV and wall is within 30 cm, "Up to
30cm" is recommended.
Selects multiplex sound mode (if available) (p. 61)
●
Normally : Stereo
●
Stereo signal cannot be received: Mono
●
M1 / M2 : Available while mono signal is transmitted
25
Advertisement
Table of Contents
