Table of Contents
Advertisement
7 Set Channels
For the initial setup, the system will remind you
to select network connection or TV channel
installation.The Section provides the instructions
on how to reinstall and fine-tune channels.
Automatic Channel Searching
1. Press
key.
2. Select
Channels > Channel Search
press OK key.
3. Press ▲/▼ key to select Start to enter, then
select country/region, and select your
channel type. After that press OK key to
begin automatic channel searching.
Note
This function can be used only in TV
mode.
Manual Channel Setting
Step 1 Select System
1. Press
key.
2. Select
Channels > Analog Channel Manual
Installation.
3. Choose to begin scanning and fine-tuning.
Note
Frequency fine-tuning can be performed
only when the source is ATV.
Step 2 Search and Store New Channels
1. Press
key.
2. Select
Channels > Analog Channel Manual
Installation > Find Channel.
You can directly input the channel
frequency.
Choose to Scan and then press OK key
to begin scanning.
3. Upon searching completion, select Save to
quit the current interface.
Step 3 ATV Fine Tuning
1. Press
2. Select
Installation
3. Select Decrease or Increase to adjust the
frequency.
Search Digital Channels
1. Press
2. Select
and then
Installation
3. Directly input the channel frequency.
4. Choose Scan and then press OK key to
begin scanning.
EN 15
Save the searched channels.
key.
Channels > Analog Channel Manual
>
Fine
Tune.
key.
Channels > Digital Channel Manual
and then press OK key.
Advertisement
Table of Contents
