Table of Contents
Advertisement
Controlling the Projector through a LAN Environment
The projector supports Crestron® software. With correct settings for the LAN
Control Settings menu, you can manage the projector from a computer using a web
browser when the computer and the projector are properly connected to the same
local area network.
Configuring the LAN Control Settings
• If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the
projector and the other end to the RJ45 port.
2. Open the OSD menu and go to the
Press Enter to display the
to open the
LAN Control Settings
3. Highlight
LAN Settings
4. Press
to highlight Apply and press Enter.
5. Please wait for around 15 - 20 seconds, and then re-enter the
page. The Projector IP Address,
settings will be displayed. Make note of the IP address displayed in the
Projector IP Address row.
NOTE:
• If the Projector IP Address still does not appear, contact your network
administrator.
• If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway and DNS Server
sure the cables are properly connected and perform the procedures above again.
ADVANCED
LAN Control Settings
menu directly.
and press
/
to select
Subnet Mask, Default Gateway, DNS Server
31
>
LAN Control Settings
page. Or you can press
DHCP
ON.
LAN Settings
settings will display 0.0.0.0. Make
menu.
Network
Advertisement
Table of Contents
