Table of Contents
Advertisement
2. Select the Network menu and press
3. Select Network Settings and press
Note: If the Remote Password and the Web Control Password have not been set, a screen appears
prompting you to set them. Enter passwords up to 32 characters long. These passwords are used
for accessing the projector over a network, and you do not need to enter them to access the Network
Settings menu after you set them.
4. Select the Mail Notification menu and press
5. Turn on Mail Notification.
6. Enter the IP address for the SMTP Server setting.
Note: Do not use 127.x.x.x (where x is a number from 0 to 255).
7. Select a type of Authentication for the SMTP server.
8. Select a number for the SMTP server Port Number setting, from 0 to 65535 (default is 25).
9. Enter a User Name for the SMTP server.
10. Enter a Password for the SMTP server authentication.
11. Enter the sender's email address as the From setting.
12. Choose an Address field, enter the e-mail address, and select the alerts you want to receive there.
Repeat for up to three addresses. Your e-mail address can be up to 64 alphanumeric characters
long.
13. If you are using the PJLink protocol for projector control, turn on the PJLink setting in the Projector
Control menu and enter the IP address where you want to receive PJLink notifications as the
Notified IP Address setting.
14. When you finish selecting settings, select Return and press
Settings menu.
15. Select Set, and follow the on-screen instructions to save your settings and exit the menus.
Enter.
Enter.
Enter.
Enter to return to the Network
75
Advertisement
Table of Contents
