Table of Contents
Advertisement
ß`
Speed-controlled volume
"SCVOL 124" (- - ... 144)
Setting is only possible if a speed-control-
led signal is present on the SCV connection
(A1).
" SCVOL - - " : SCV switched off.
" SCVOL 144 " : maximum effect.
í
For reasons of safety the following
setting should be carried out by the
passenger!
Setting
1. Car standing still, motor running:
¢ ¢
set desired volume with
2. Prepare EXPERT setting:
"
LOUD
press the
button until signal
EXPERT
sounds.
¢ ¢
Turn
rotary knob until e.g.
" SCVOL ..." appears in the display.
"
LOUD
Briefly press the
button:
EXPERT
»
« appears in the display.
E
3. At higher speed:
¢ ¢
use the
rotary knob to set the required
volume, e.g." SCVOL 124 " in display.
"
LOUD
Press the
button until the signal
EXPERT
sounds.
ßQ
On/Off switching delay for connected
booster
(booster switching voltage = contact C6)
" BDLY ... " (O6 ... 99)
If "switching noise" occurs: increase set
value until switching noise is no longer
audible.
ßW
Activating the coding
If "CODE" appears in the diplay, coding is
not activated.
If "SAFE" appears in the display, coding is
activated.
rotary knob.
Maintenance and Care
EXPERT
Your car radio has been designed throughout
to ensure maintenance-free operation over an
extended period of time.
If a malfunction
should occur, please consult your dealer.
In the Federal Republic of Germany, Grundig
car radios can be exchanged by your dealer
on request for a works-tested exchange unit
in the event of a defect occuring.
Please note:
It is a condition for your dealer to participate
in this exchange system that the guarantee
seal on your car radio is not damaged.
Cassettes must not be subjected to high
temperatures (see manufacturer's specifica-
tions) and should be put into their case after
use.
The front panel of the car radio must only be
cleaned with a soft, dust-absorbent, anti-static
cloth. Polishing and cleansing agents may
damage the surface of the trimplate.
The tape head must be free of tape dust in
order to avoid losses in the treble tones
during playback. Therefore you should clean
the tape head with a cleaning cassette after
every 50–100 hours of operation.
21
GB
Advertisement
Table of Contents
