Onboard Headers And Connectors - ASROCK FM2A88M-DG3+ User Manual

2.6 Onboard Headers and Connectors

Serial ATA3 Connectors
(SATA_1: see p.6, No. 10)
(SATA_2: see p.6, No. 7)
(SATA_3: see p.6, No. 9)
(SATA_4: see p.6, No. 8)
USB 2.0 Headers
(9-pin USB_7_8)
(see p.6 No. 14)
(9-pin USB_9_10)
(see p.6 No. 13)
USB 3.0 Header
(19-pin USB_11_12)
(see p.6 No. 6)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.11 No. 20)
16
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
USB_PWR
P-
P+
GND
1
GND
P+
P-
USB_PWR
Vbus
IntA_PA_SSRX-
IntA_PA_SSRX+
GND
IntA_PA_SSTX-
IntA_PA_SSTX+
GND
IntA_PA_D-
IntA_PA_D+
OUT_RET
MIC_RED
PRESENCE#
GND
These four Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Besides four default USB 2.0
ports on the I/O panel, there
DUMMY
are two USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
Besides two default USB 3.0
Vbus Vbus
ports on the I/O panel, there is
IntA_PB_SSRX-
IntA_PB_SSRX+
one USB 3.0 header on this
GND
IntA_PB_SSTX-
motherboard. This USB 3.0
IntA_PB_SSTX+
header can support two USB 3.0
GND
IntA_PB_D-
ports.
IntA_PB_D+
Dummy
This is an interface for the front
OUT2_L panel audio cable that allows
J_SENSE
convenient connection and
OUT2_R
MIC2_R
control of audio devices.
MIC2_L
1