Table of Contents
Advertisement
5. DESCRIPTION (page 3)
The terminology below will be used repeatedly on the following
pages.
5.1 Description of the appliance
A1. Water tank lid
A2. Tank extraction handle
A3. Water tank
A4. Cup warmer
A5. Boiler outlet
A6. ON/OFF switch
A7. Cup tray
A8. Drip tray full indicator
A9. Drip tray
A10. Mugs or glasses tray
A11. Steam dial
A12. Hot water/steam spout
A13. Hot water/steam connection nozzle
A14. Cappuccino maker selection ring
A15. Hot water/steam connection tube
5.2 Description control panel
B1. One cup button
B2. ON light on button (white)
B3. Two cups button
B4. ON light on button (white)
B5. Steam button
B6. ON light on button (white)
B7. Descale light (orange)
5.3 Description of the accessories
C1. Filter holder
C2. 1 cup filter (
symbol under filter)
C3. 2 cup filter (
symbol under filter)
C4. Pod filter (
symbol under filter)
C5. Measure/presser
C6. Water softener filter (*not included, can be purchased
from authorised Customer Services)
6. INSTALLING THE APPLIANCE
Important!
When you install the appliance, you should respect the follow-
ing safety warnings:
•
Water penetrating the coffee maker could cause damage.
Do not place the appliance near taps or sinks.
•
The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
•
Arrange the cord in such a way that it cannot be damaged
by sharp edges or contact with hot surfaces (e.g. electric
hot plates).
•
The appliance gives off heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm be-
tween the surfaces of the appliance and the side and rear
walls and at least 15 cm above the machine.
•
Clean all the removable parts with tap water.
6.1 Connecting the appliance
Danger!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only. If
the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.
7. FILLING THE WATER TANK
Please note:
Before first use, wash all the accessories and water tank with
warm water.
1. Extract the tank by pulling it upwards (fig. 1).
2. Open the lid and fill the tank with fresh clean water, taking
care not to exceed the MAX level (fig. 2). Put the tank back
in the appliance, pressing lightly to open the valves located
on the bottom of the tank.
3. More simply, the tank can also be filled without removing
it, pouring the water directly from a jug.
Important:
Never operate the appliance without water in the tank or with-
out the tank.
Please note:
It is normal for there to be water in the space under the tank.
This should therefore be dried regularly with a clean sponge.
8. FIRST USE
At first use, rince the internal circuit as follows:
1. Turn the appliance on by pressing the ON/OFF switch (fig.
3). The appliance performs a self-diagnosis cycle, indicated
by sequential flashing of the three buttons.
2. The
and
is heating up. When the lights stop flashing and remain on
steadily, the appliance is ready for operating the rinse.
3. Attach the filter holder to the appliance (fig. 9).
8
lights flash to indicate the appliance
Advertisement
Table of Contents
