Fujitsu ETERNUS4000' ETERNUS8000 Server Connection Manual page 10

Chapter 1 Workflow
>
P3AM-4172-02ENZ0 Server Connection Guide (iSCSI) ETERNUS Disk Storage System Settings
Set Server iSCSI
Set IP addresses, aliases, and iSCSI names for servers.
Refer
-
"2.1.3 Setting the Server iSCSI Host" (page 15)
Set Host-Affinity Groups
Define the relationship between the iSCSI card HBA and LUN group.
Refer
-
"2.1.5 Creating and Allocating LUN Groups (Setting Host-Affinity Groups)" (page 15)
When setting CHAP authentication
Set CHAP Authentication
Set CHAP authentication to enhance
security for an iSCSI connection.
Refer
-
"2.1.6 Setting CHAP Authentication"
(page 16)
Set the CA Reset Groups
Assign the iSCSI ports of the ETERNUS Disk storage system to the same reset group,
depending on the connection conditions.
Refer
-
"2.2.1 Setting the CA Reset Groups" (page 17)
After completing all the required procedures in this manual, follow the procedures in
"ETERNUS Disk storage systems Server Connection Guide (iSCSI)" for each OS.
When not setting CHAP authentication
10
Copyright 2010 FUJITSU LIMITED