Advertisement
Air Filter
The air filter behind the inlet grille should be checked and cleaned at least once
every 2 weeks (or as necessary) to maintain optimal performance of the air
conditioner.
How to remove the air filter
1
The grille may be opened from the top or bottom for easy maintenance
after installation.
2
Open the inlet grille by pulling off the exposed door on the bottom or top of
the unit (based on installation). Refer to the Using the reversible inlet
grille in the Hardware Installation Guide section if you want to change the
opening side.
3
Pull the tab slightly to release the filter. Pull the filter in the same direction
as the opening.
4
Clean the filter with warm, soapy water. The water should be below 40°C
(104°F).
5
Rinse off and gently shake off excess water from the filter. Let it dry
before replacing it.
Drainage (Optional)
The base pan may overflow due to high humidity. To drain the excess water,
remove the drain cap from the back of the unit and secure the drainpipe.
1
Take the drain pan which is shipped in the air discharge or on the barrier.
2
Remove the rubber plug from the bottom of the base pan.
3
Install the drain pan over the corner of the cabinet where
you removed the plug with 4 (or 2) screws.
4
Connect the drain hose to the outlet
located at the bottom of the drain pan. You
can purchase the drain hose or tubing
locally to satisfy your particular needs.
(Drain hose is not supplied).
5
Select the most appropriate connection
from among the following figures (by
considering the hole of the unit) to fit drain
pan to your own unit.
CABINET
DRAIN
DRAIN HOSE
PAN
12
Drain pipe
Drain cap
SCREW
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Advertisement
