LG DT25WTGK Series Owner's Manual page 44

44 TROUBLESHOOTING
Problem
The display shows
• Products with original serial numbers that have been removed, altered, or cannot be readily determined. Model
and serial numbers, along with original retail sales receipts, are required for warranty validation.
• Increases in utility costs and additional utility expenses.
• Repairs when your product is used for other than normal and usual household use (e.g. commercial use, in
• Costs associated with removal of your product from your home for repairs.
• The removal and reinstallation of the product if it is installed in an inaccessible location or is not installed in
accordance with published installation instructions, including LG's owner's and installation manuals.
• Damage resulting from misuse, abuse, improper installation, repair, or maintenance. Improper repair includes
Filter is clogged.
Not heating, long dry time
Duct is clogged.
Not heating, long dry time
Excessive duct length
and/or multiple elbows
Not heating, long dry time
Improperly connected
power cord or electrical
outlet issue.
No Power
Not Heating
Gas valve is not turned
on. (Gas Dryer)
Not heating
Door Reversal
The cost of repair or replacement under these excluded circumstances shall be borne by the consumer.
TO OBTAIN WARRANTY SERVICE AND ADDITIONAL INFORMATION
For additional product information, visit the LG website at http://www.lg.com
Possible Cause
The duct work is about 80% - 95%
blocked. ("d80", "d90" or "d95"
error code is displayed for 2
hours only)
House exhaust system blocked.
Solutions
Do not use the dryer until the exhaust
system has been cleaned and/or repaired.
Using the dryer with a severely restricted
exhaust is dangerous and could result in
a fire or other property damage.
Check the outside dryer vent while the
dryer is operating to make sure there is
strong airflow.
If the exhaust system is extremely long,
have it repaired or rerouted.
Keep the area around the dryer clean and
free of clutter.
s owner's manual.
Check vent hood for damage or lint
clogging.
Make sure the area around the vent hood
is clear.
Clean the hood and duct.
Keep exhaust ducts as
short as possible, using as
few elbows and bends as
possible.
Reconnect power cord,
replace house fuse or reset
breaker. If outlet is issue,
electrician may be required.
Open the gas valve.
Instructions for door reversal
can be found in the owner's
manual.