Preparation Before Operation - Daikin FTKF25XVMV Operation Manual

READ BEFORE OPERATION

Preparation Before Operation

„ To set the batteries
Slide the back cover to take it off.
„ To operate the remote controller
• To use the remote controller, aim the transmitter at the indoor
unit. If there is anything blocking signals between the unit and
the remote controller, such as a curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 7m.
„ To fix the remote controller
holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, etc. with the screws
supplied with the holder.
3. Place the remote controller in the remote controller holder.
„ Turn the breaker on
• After the power is turned on, the flap of the indoor unit opens and
close once to set the reference position.
ATTENTION
„ About batteries
• When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately one year. If the remote controller display begins to fade
and the degradation of reception performance occurs within a year, however, replace both two
batteries with new size AAA.LR03 (alkaline) batteries.
• The attached batteries are provided for the initial use of the system. The usable period of the
batteries may be short depending on the manufactured date of the air conditioner.
• When battery power has run out, "
replacing. In some cases, when battery consumption is accelerated owing usage conditions,
signal reception may decline before "
„ About remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to
somewhere else, or consult the shop.
8
Position and
correctly!
1
2
Set two dry batteries
AAA.LR03 (alkaline).
" will begin blinking as an alert that the batteries need
" begins blinking.
Set the back cover as before.
Receiver
Remote controller
Remote
controller
Screws
holder
3