Table of Contents
Advertisement
LUBRICATION
•
Using a pressure lubricating gun, lubricate the front castor wheel
axles and the front pivot axle with No. 2 multipurpose lithium
grease after every 10 hours of service.
•
Periodically lubricate all other pivot points with a quality lubricat-
ing oil.
GENERAL BATTERY INFORMATION
WARNING
Should battery acid accidentally splatter into the eyes or onto the
skin, rinse the affected area immediately with clean cold water. If
there is any further discomfort, seek prompt medical attention. If acid
spills on clothing, first dilute it with clean water, then neutralize with a
solution of ammonia/water or baking soda/water.
WARNING
NEVER connect (or disconnect) battery charger clips to the battery while
the charger is turned on, as it can cause sparks. Keep all sources of ignition
(cigarettes, matches, lighters) away from the battery. The gas generated
during charging can be combustible. As a further precaution, only charge
the battery in a well ventilated area. Always shield eyes and protect skin
and clothing when working near batteries.
WARNING
Batteries contain sulfuric acid and may emit explosive gases. Use extreme
caution when handling batteries. Keep batteries out of the reach of children.
Battery Maintenance
The battery is filled with battery acid and then sealed at the factory.
However, even a "maintenance free" battery requires some mainte-
nance to ensure its proper life cycle.
Spray the terminals and exposed wire with a battery terminal sealer,
or coat the terminals with a thin coat of grease or petroleum jelly, to
protect against corrosion.
Always keep the battery cables and terminals clean and free of
corrosion.
Avoid tipping. Even a sealed battery will leak electrolyte when tipped.
SERVICE AND MAINTENANCE
BATTERY REMOVAL
Battery posts, terminals and related accessories contain lead and
lead compounds. Wash hands after handling.
The battery is located on the right/rear of the riding mower beneath the
seat box frame. To remove the battery:
1.
Remove the two hex tapping screws from the battery hold-down
bracket and remove the bracket. Use care to avoid losing the trim
strip from the bottom of the bracket. See Figure 29.
Battery Hold Down Bracket
Hex Cap Screw
2.
Remove the hex cap screw and sems nut securing the black
negative battery lead to the negative battery post (marked NEG).
Move the cable away from the negative battery post.
3.
Remove the hex cap screw and sems nut securing the red posi-
tive battery lead to the positive battery post (marked POS).
4.
Carefully lift the battery out of the riding mower.
5.
Install the battery by repeating the above steps in the reverse
order.
Always connect the positive lead to the battery before connecting the
negative lead. This will prevent sparking or possible injury from an
electrical short caused by contacting the riding mower body with tools
being used to connect the cables.
26
WARNING
Hex Tap Screw
Sems Nut
Trim Strip
Figure 29
WARNING
Advertisement
Table of Contents
