Checking The Rear Brake Pad Insulator; Checking The Brake Fluid Level - Yamaha WR250F 2017 Owner's Service Manual

i. Install the brake caliper "12" and the rear
wheel "13".
Refer to "REAR WHEEL" on page 5-9.
j. Tighten the pad pin "14".
Pad pin
17 Nm (1.7 m·kgf, 12 ft·lbf)
14
k. Install the pad pin plug "15" and the protector
"16".
Pad pin plug
2.5 Nm (0.25 m·kgf, 1.8 ft·lbf)
Bolt (protector)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
15
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Check:
• Brake fluid level
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-30.
4. Check:
• Brake pedal operation
A softy or spongy feeling  Bleed the brake
system.
Refer to "BLEEDING THE BRAKE SYS-
TEM" on page 3-25.
13
12
16
3-30
CHECKING THE REAR BRAKE PAD INSU-
EAS2GBB108
LATOR
1. Remove:
• Brake pads
Refer to "REAR BRAKE" on page 5-23.
2. Check:
• Rear brake pad insulator "1"
Damage  Replace.

CHECKING THE BRAKE FLUID LEVEL

EAS2GBB109
1. Stand the vehicle upright on a level surface.
TIP
In order to ensure a correct reading of the brake
fluid level, make sure that the top of the brake
fluid reservoir is horizontal.
2. Check:
• Brake fluid level
The minimum level mark "a" or below 
Add.
Specified brake fluid
DOT 4
A. Front brake
B. Rear brake
CHASSIS