Table of Contents
Advertisement
en Water softening system/special salt
Overview of menu
The dishwasher has been preset with
certain settings for your convenience.
Setting up
• Water hardness
•:‹‹ - •:‹ˆ
§ Rinse aid
§:‹‹ - §:‹‡
š ExtraDry
š:‹‹ - š:‹‚
' Hot water *
':‹‹ - ':‹‚
˜ Auto Power Off
˜:‹‹ - ˜:‹ƒ
* depending on the configuration of your specific dishwasher
--------
+
Water softening
system / special salt
T o ensure good rinsing results, the
W a t e r s o f t e n i n g s y s t e m / s p e c i a l s a l t
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the
water softening system
of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).
12
Factory setting
•:‹...
§:‹†
š:‹‹ / Off
':‹‹ / Off
˜:‹‚
The settings can be found in the
individual chapters. You can change
these factory settings.
Description
Setting water hardness. When using
Multitabs, select the lowest setting.
Amount of rinse aid affects drying. When
using Multitabs, select setting 0.
Improved drying for glasses and plastic
tableware.
The dishwasher can be connected to
either hot (40-60°C) or cold water
(<40°C).
Appliance automatically switches off at
the end of each wash.
Water hardness table
Advertisement
Table of Contents
