Carrier 40VK S-8S-TST Series Owner's Manual page 7

• When the air conditioner must be transported by hand, carry it by two or
more people.
Installation
• Only a qualified installer (*1) or qualified service person (*1) is allowed to
carry out the electrical work of the air conditioner. Under no circumstances
must this work be done by an unqualified individual since failure to carry out
the work properly may result in electric shocks and/or electrical leaks.
• After the installation work has been completed, have the installer explain
about the circuit breaker positions. In the event that trouble has occurred in
the air conditioner, set the circuit breaker to the OFF position, and contact a
qualified service person (*1).
• If the unit is installed in a small room, take appropriate measures to prevent
the refrigerant from exceeding the limit concentration even if it leaks.
Consult the dealer from whom you purchased the air conditioner when you
implement the measures. Accumulation of highly concentrated refrigerant
may cause an oxygen deficiency accident.
• Do not install the air conditioner in a location that may be subject to a risk
of exposure to a combustible gas. If a combustible gas leaks and becomes
concentrated around the unit, a fire may occur.
• Use the company-specified products for the separately purchased parts. Use
of non-specified products may result in fire, electric shock, water leakage or
other trouble. Have the installation performed by a professional.
• Confirm that earthing is performed correctly.
Operation
• Before opening the front panel of the indoor unit or service panel of the
outdoor unit, set the circuit breaker to the OFF position. Failure to set the
circuit breaker to the OFF position may result in electric shocks through
contact with the interior parts. Only a qualified installer (*1) or qualified
service person (*1) is allowed to remove the front panel of the indoor unit or
service panel of the outdoor unit and do the work required.
• Inside the air conditioner are high-voltage areas and rotating parts. Due to
the danger of electric shocks or of your fingers or physical objects becoming
trapped in the rotating parts, do not remove the front panel of the indoor unit
or service panel of the outdoor unit. When work involving the removal of
these parts is required, contact a qualified installer (*1) or qualified service
person (*1).
• Do not move or repair any unit by yourself. Since there is high voltage
inside the unit, you may get electric shock when the cover and main unit is
removed.
• Use of a stand more than 50 cm high to clean the filter of the indoor unit or to
carry out other such jobs constitutes working at heights. Due to the danger of
falling off the stand and injuring yourself while working at heights, this kind of
work should not be done by unqualified individuals. When this kind of work
must be carried out, do not do it yourself but ask a qualified installer (*1) or
qualified service person (*1) to do it for you.
- 6 -
EN