Maintenance
Troubleshooting
Replacement
Bulbs
1.
2.
3.
4.
WARNING
Before replacing a bulb, turn off the oven and unplug the power cord.
•
•
Use only 25-40 W / 220-240 V, 300 °C heat-resistant bulbs. You can purchase
approved bulbs at a local Samsung service center.
•
Always use a dry cloth when handling a halogen bulb. This is to prevent the
bulb from being tampered with fingerprints or sweat, resulting in a shortened
lifecycle.
Side oven light
1.
2.
3.
46 English
Remove the glass cap by turning anti-
clockwise.
Replace the oven light.
Clean the glass cap.
When done, follow step 1 above in the
reverse order to reinsert the glass cap.
Hold the lower end of the cover of the
side oven light with one hand, and use
a flat-sharp tool such as a table knife to
remove the cover as shown.
Replace the side oven light.
Reinsert the light cover.
Troubleshooting
Checkpoints
If you encounter a problem with the oven, first check the table below and try the
suggestions. If the problem continues, contact a local Samsung service centre.
Problem
Cause
The buttons cannot
•
If there is foreign
be pressed properly.
matter caught
between the buttons.
•
Touch model: if there
is moisture on the
exterior.
•
If the lock function
is set.
The time is not
•
If there is no power
displayed.
supplied.
The oven does not
•
If there is no power
work.
supplied.
The oven stops while
•
If it is unplugged from
in operation.
the power socket.
If continuous cooking
The power turns off
•
during operation.
takes a long time.
•
If the cooling fan does
not work.
•
If the oven is installed
in a place without
good ventilation.
•
When using several
power plugs in the
same socket.
There is no power to
•
If there is no power
the oven.
supplied.
Action
•
Remove the foreign
matter and try again.
•
Remove the moisture
and try again.
•
Check whether the
lock function is set.
•
Check whether there
is power supplied.
•
Check whether there
is power supplied.
•
Reconnect the power.
After cooking for a
•
long time, let the oven
cool.
•
Listen for the sound
of the cooling fan.
•
Keep the gaps
specified in the
product installation
guide.
•
Use a single plug.
•
Check whether there
is power supplied.