Setting Up Home Connect; Home Connect Settings - Siemens EQ.700 classic TP7 Series Information For Use

en Home Connect
12.2 Setting up Home Con-
nect
Requirements
The Home Connect app has been
¡
installed on your mobile device.
The appliance is receiving signals
¡
from the WLAN home network (Wi-
Fi) at its installation location.
Open the Home Connect app and
1.
scan the following QR code.
Overview of the Home Connect settings
You can find an overview of the Home Connect settings and network settings
here.
Basic setting
WiFi connection
Remote start
Add mobile
device
Network informa-
tion
Delete network
settings
Software update
20
Selection
On
Off
On
Off
-
-
-
-
Follow the instructions in the
2.
Home Connect app.
12.3 Home Connect settings
Adapt Home Connect to your needs.
You can find the Home Connect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
Home Connect has been set up and
whether the appliance is connected
to your home network.
Description
Switch off the wireless module during
long absences or to save energy.
Note: In networked standby mode
your appliance requires max. 2 W.
Switch remote start on the appliance
on and off.
Note: With the Home Connect app
only switch-off is possible.
Connect the appliance to the "Home
Connect" app or additional accounts.
Display network information and appli-
ance information.
Note: You cannot operate your appli-
ance via the "Home Connect" app
without a network connection.
Note: This setting is only available
with a software update.