Table of Contents
Advertisement
CH5000 & CH7500 Chiller Operator's & Installation Manual
INSTALLATION
L
OCATION
o
Install the chiller indoors in a well ventilated area where ambient temperatures will never fall below 40
F or rise above
o
o
110
F. To obtain optimum cooling capacity, the ambient temperature should be 80
F or below.
Standard CH Chillers have air-cooled condensers. On air-cooled units it is important that the air intake and discharge
are not obstructed. Avoid hot air discharge from other equipment or enclosed areas where heat buildup could cause a
significant rise in ambient temperatures. A minimum of two feet of space on all four sides of the chiller will be sufficient
to prevent obstruction. Water-cooled units should be located near a water source and drain.
Electrical Junction Box
Control Panel
(See Detail)
Tank Fill 1 In. FPT
Tank Drain
Air Outlet
(Air Inlet on Opposite Side)
Water Outlet
Tank Level Gauge
Water Inlet
Figure 1. Installation Details
E
LECTRICAL
All wiring must conform to the National Electric Code and any applicable local codes. The chiller must be
PERMANENTLY wired by means of electrical conduit to a properly fused disconnect of proper amperage or wired to a
properly rated power cord and plugged into an outlet with the appropriate disconnect and amperage rating. The
Publication Number: 91961OPR
- 4 -
© 2006-2011, IMI Cornelius Inc.
Advertisement
Table of Contents
