Operation - Craftsman 247.370301 Operator's Manual

Recoil Starter
Grass Catcher
Blade Control
The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the upper handle to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.
Cutting Height Adjustment Lever
One adjustment lever is located on the right rear wheel and one is located on the
right front wheel. Both levers have to be at the same position to ensure a uniform
cut. To adjust the cutting height, refer to the Assembly Section.
Grass Catcher
The grass catcher, located at the rear of the mower, is used to bag the grass
clippings for disposal at another site. Once the bag is full, remove it up through the
handles using the strap provided and empty it before any further mowing.
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Cutting Height
Adjustment
Lever
WARNING
Meets ANSI Safety Standards
Blade Control
Gas Cap
Oil Fill
Figure 11
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Gas Cap
Remove the gas cap to add fuel to the fuel tank. Use clean, fresh, regular unleaded
gasoline.
Oil Fill Cap/Dipstick
Refer to the Maintenance section for instructions on checking the oil.
Spark plug
Refer to the Maintenance section for instructions on spark plug replacement.
11
Cutting Height
Adjustment
Lever
Spark Plug