Advertisement
Dual DF/ED 2XX Lid Kit Installation Instructions
4. Set the lid assembly onto the dispenser. Using the slotted holes on the side of the lid as a template, drill four (4)
9/64" diameter holes at the bottom of the slots (Figure 2).
!
CAUTION:
Use extreme care not to drill into the hopper. Use a drill stop to ensure that the drill bit does not penetrate deeper than
¼" past the sheet metal. Failure to do so could result in a hole in the hopper, greatly reducing the efficiency of both the
dispenser and ice maker.
5. Fasten the lid to the dispenser with four (4) #8 sheet metal screws (item 5), two on each side.
6. Seal the ice maker to the top of the dispenser as follows:
A. Run beads of RTV (item 7) around the opening in the lid assembly and the inside of the perimeter of
the ice maker outline so that the ice maker sets on the RTV. Make sure that some RTV is applied
inside the nutserts on the lid assembly.
B. Set the ice maker onto the lid and position it as required.
C. Insert the thumbscrews (item 5) into the lid to attach the ice maker to the lid (Figure 3).
D. Wipe away the excess RTV.
7. Attach the mounting brackets (item 4) to the to the ice makers and lid assemblies with the #8 sheet metal screws
(item 5) (Figure 2).
8. Follow the ice maker manufacturer's instructions to complete the installation of the ice maker.
9. Install the bin-stat (item 14) per the instructions provided with that kit.
10. Install the covers (item 1) into the slots on the lid assemblies (Figure 3).
11. Apply the label (item 6) on the front of the cover.
Publication Number: 620919550
- 2 -
© 2001-2010, IMI Cornelius Inc.
Advertisement
