Driver Information Center (Dic); Dic Operation And Displays; (Using Trip Odometer Reset Stem) - GMC Sierra Denali 2009 Owner's Manual

Driver Information Center (DIC)

Your vehicle has a Driver Information Center (DIC).
The DIC displays information about your vehicle. It also
displays warning messages if a system problem is
detected.
All messages will appear in the DIC display located
below the tachometer in the instrument panel cluster.
The DIC comes on when the ignition is on. After a short
delay, the DIC will display the information that was
last displayed before the engine was turned off.
For the displays available using DIC buttons, see "DIC
Operation and Displays (Using DIC Buttons)" later
in this section and DIC Vehicle Customization (With DIC
Buttons) on page 3-65.
For the displays available using the trip odometer reset
stem, see "DIC Operation and Displays (Using Trip
Odometer Reset Stem)" later in this section.
3-48

DIC Operation and Displays

(Using Trip Odometer Reset Stem)

The DIC has different displays which can be accessed
by pressing the trip odometer reset stem located on
the instrument panel cluster. Pressing the trip odometer
reset stem will also turn off, or acknowledge, DIC
messages.
You can use the trip odometer reset stem to view the
following displays: odometer, engine hours, trip
odometer, compass zone setting, compass recalibration
and display language.
Trip Odometer Reset Stem Menu Items
Odometer
Press the trip odometer reset stem until ODOMETER
displays. This display shows the distance the vehicle
has been driven in either miles (mi) or kilometers (km).
Engine Hours
To display the ENGINE HOURS, place the ignition in
LOCK/OFF or ACC/ACCESSORY, then press and hold
the trip odometer reset stem for four seconds while
viewing the ODOMETER. This display shows the total
number of hours the engine has run.