White Outdoor LT-180H Operator's Manual page 15

Hydrostatic lawn tractor
Hide thumbs Also See for LT-180H:
Table of Contents

Advertisement

inch above the ground when the tractor is on a smooth,
flat surface such as a driveway.
WARNING:
from the discharge opening of the cutting
deck.
NOTE:
The deck wheels are an anti-scalp feature of
the deck and are not designed to support the weight of
the cutting deck.
Refer to the ADJUSTMENTS section of this manual for
more detailed instructions regarding various deck
adjustments.
STARTING THE ENGINE
WARNING:
the interlock system is malfunctioning. This
system was designed for your safety and
protection.
NOTE:
Refer to the TRACTOR SET-UP section of this
manual for Gasoline and Oil fill-up instructions.
Insert the tractor key into the ignition switch.
Place the PTO knob (or lever) in the disengaged
(OFF) position.
Engage the tractor's parking brake.
Pull the choke control outward.
Turn the ignition key clockwise to the START
position. After the engine starts, release the key. It
will return to the ON position.
IMPORTANT:
Do NOT hold the key in the START
position for longer than ten seconds at a time. Doing so
may cause damage to your engine's electric starter.
NOTE:
If starting problems are encountered, refer to
the TROUBLESHOOTING section of this manual.
After the engine starts, slowly release the brake pedal.
As the engine warms up, gradually push the choke
control knob inward to open up the choke plate on the
engine's carburetor.
NOTE:
Do NOT leave the choke control on while
operating the tractor. Doing so will result in a "rich" fuel
mixture and cause the engine to run poorly.
STOPPING THE ENGINE
WARNING:
stop the engine, disconnect the spark plug
wire(s) and ground against the engine.
Thoroughly inspect the machine for any
damage. Repair the damage before restarting
and operating
If the blades are engaged, place the PTO knob (or
lever) in the disengaged (OFF) position.
Keep hands and feet away
Do not operate the tractor if
If you strike a foreign object,
Turn the ignition key counterclockwise to the OFF
position.
Remove the key from the ignition switch to prevent
unintended starting.
DRIVING THE TRACTOR
WARNING:
cessive speed and sudden stops.
WARNING:
tractor without first placing the PTO knob (or
lever) in the disengaged (OFF) position,
depressing the brake pedal and engaging the
parking
brake.
unattended, also turn the ignition key off and
remove the key.
Briefly depress the brake pedal to release the
parking brake. Move the throttle lever into the FAST
(rabbit) position.
To travel FORWARD, slowly depress the upper
portion of the drive pedal forward until the desired
speed is achieved. See Figure 11.
Reverse
Drive Pedal
To travel in REVERSE, check that the area behind
is clear then slowly depress the lower portion of the
drive pedal with the ball of your foot (NOT your heel)
until the desired speed is achieved. See Figure 11.
IMPORTANT:
Do NOT attempt to change the
direction of travel when the tractor is in motion. Always
bring the tractor to a complete stop before pivoting the
drive pedal from forward to reverse or vice versa.
ENGAGING THE PARKING BRAKE
To engage the parking brake:
Fully depress the brake pedal and hold it there while
gently pushing the parking brake button inward.
Hold the parking brake button in while removing
your foot from the brake pedal.
Once engaged, the parking brake button and the
brake pedal will lock in the "down" position.
To disengage the parking brake:
Slightly depress the brake pedal.
15
Avoid sudden starts, ex-
Do not leave the seat of the
If
leaving
the
Forward
Brake Pedal
Fender/
Running Board
Figure 11
tractor

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lt-18hLt-200hWlt-18013b0616g59013a6616h590

Table of Contents