Cornelius P/N 629087002 Installation Instructions

INSTALLATION INSTRUCTIONS

F I M
OR CE AKER
For Hoshizaki Model Series: KM/KML 200/250/400/450/500/600/630/650
Kit Part No.
629087002
629087003
Item No. Part No.
620034802
1
620034902
620034808
2
620034901
3 22127
4 620701601
5 70209
6 50904
7 620028305
8 70164
9 70100
10 91957
11 620917305
!
WARNING:
Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the
user. Verify that all the power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
All ice baffle plates and bin stats, if included or recommended in this kit, must be installed as directed in this manual or
the equipment manufacturer's instructions.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
All of the attachment screws and plates must be installed as directed in this manual.
Failure to comply could result in serious injury, death or damage to the equipment.
Perform the following procedure to install the adapter kit.
1. Unpack kit. Make sure all parts in kit are present and in good condition.
2. Position the ice maker adapter lid on the dispenser flush with the rear of the cabinet as shown in Figure 1.
3. Seal ice maker to top of the dispenser adapter lid as follows:
A. Locate the ice maker flush with the rear of the lid and centered (for 24-1/2 inches wide dispenser) as
shown in Figure 1. Run a bead of RTV on the lid inside the perimeter of the ice maker base outline so
that the ice maker will set on the RTV.
Release Date: November 10, 2010
© 1999-2010, IMI Cornelius Inc.
A K (P/N 629087002)
DAPTER IT
Table 1. Applicable Models
DF/ED150 - 6 Valve (22 inches wide)
DF/ED 150 - 8 Valve (24-1/2 inches wide)
Table 2. Loose Shipped Parts
Adapter Lid (629087002 Kit)
Adapter Lid (629087003 Kit)
Manual Ice Fill Cover (629087002 Kit)
Manual Ice Fill Cover (629087003 Kit)
Bracket, Ice Maker Mounting
Screw, Sheet Metal, No.10 by 1/2-inch Long
Thumbscrew, No. 8-32 by 3/8-inch Long
RTV, 3-oz. Tube
Bracket, Bin Thermostat
Screw, Truss-Head, No. 8-32 by 3/4-inch Long
Nut, Nylok, No. 8-32
Label, "Disconnect Power Before Cleaning"
Installation Instructions
www.cornelius.com
Ice Maker Adapter Kit Installation Instructions
AND
Dispenser Model
Name
- 1 -
(P/N 629087003)
Revision: C
Publication Number: 620917305
Qty.
1
1
1
1
2
12
1
1
1
2
2
1
1