Table of Contents
Advertisement
Attaching Chute Crank
•
Remove the hairpin clip from the upper chute crank and
slide the upper chute crank into the lower chute crank. A
pair of pliers may help in this job. See Figure 3-3.
a.
Align the two holes on both chute cranks. See Figure
3-3.
b.
Secure with the hairpin clip removed earlier.
Attaching the Chute Assembly
•
Cut and remove the cable tie holding the chute assembly
to the spiral end of the chute crank.
•
Remove locknuts and screws securing one of the flange
keepers to the chute assembly. See Figure 3-4.
8
S
3— a
ectioN
SSeMbly
a
b
Fig. 3-3
Fig. 3-4
& S
-u
et
p
Fig. 3-5
•
Loosen but do not remove the locknuts and screws on the
other two flange keepers.
•
Loosen but do not remove, the chute bracket in order to
attach the chute assembly. See Figure 3-5.
•
Place the chute assembly onto chute base, making sure the
flange keepers are beneath lip of chute base. The notches
should engage with the spiral end of the chute crank. See
Figure 3-6.
Fig. 3-6
•
Retighten the two nuts which secure the chute bracket.
•
Secure flange keeper, locknuts and screws previously
removed. Tighten all flange keepers and hardware with
two 7/16" wrenches. Do not over tighten.
NOTE: If necessary the chute crank support bracket can be
adjusted so the spiral on the chute crank fully engages the teeth
on the chute assembly. Refer to the Adjustment Section.
Advertisement
Table of Contents
